#Magic window slider card die series

Cut a 5 1/4″ x 4 1/4″ Basic White cs panel & Window Sheet panel.Making the Matching Window Sheet & Inside Panel Images – The card front has the flaps and the back doesn’t & should measure 4 1/4″ Use glue to add it to the card front around your window. Die cut a Basic Black cs window frame using the largest and second largest dies from the Hippo & Friends dies.Keep in mind to center your window between the bottom of your pull and/or leaving enough room to hide your sentiment in the space between the top of your window and the bottom of your pull. Die cut out your window from the card front (second largest die from the Hippo & Friends dies).I die cut a Basic Black cs circle that I will fold in half. Also die cut or punch out the same circle to use to create your pull. Die cut or punch your pull tab at the top center of the card front (smallest circle die in the Layering Circles dies).

#Magic window slider card die series

Glue your Designer Series Paper panel (5 1/8″ x 3 7/8″) to the card front.

The side with the flaps will be your card front.

Make an angle cut on both sides from the middle into the scored flaps. Snip off the flaps that were cut away from the base.On the short side (5 1/4″) cut at 1/2 to the long side’s score line (half way) and then continue to score at 1/2″ on the bottom half and cut at 4 3/4″ to the long side’s score line (half way) and then continue to score at 4 3/4″ on the bottom half.On the long side (11″) score at 5 1/2″.Cut a Bumblebee cs pocket base – 11″ x 5 1/4″.I used the In Color Bumblebee to create this ‘Hufflepuff’ Magic Slider Card.